G
®
KYMASGARD
RTF 2 - FSE ⁄ RFTF 2 - FSE
The room temperature sensors KYMASGARD
generation is effected by conversion of indoor room light into electric energy by means of a solar generator. These sensors are used to detect
the room temperature or room humidity and to transmit the measurands via radio frequency to radio actuators and radio signal receivers ⁄ gateways.
If ambient light conditions are insufficient for energy generation, they also can be operated on a lithium battery. To do so, insert the lithium cell into
the battery holder provided. The device IDs are marked on a label in the device.
TECHNICAL DATA
Operation:
Radio technology:
Channels :
Radio transmitter module:
Measuring range, temperature:
Deviation, temperature:
Measuring range, humidity:
Deviation humidity:
Measurand acquisition:
Setpoint capture :
Transmission interval :
Range of coverage:
Enclosure:
Dimensions:
Mounting:
Ambient temperature:
Storage temperature:
Humidity:
Protection class:
Protection type:
Standards:
Type ⁄ WG02
Without operating elements :
RTF2-FSE
RFTF2-FSE
With setpoint setter :
RTF2-FSE-P
RFTF2-FSE-P
With setpoint setter, pushbutton :
RTF2-FSE-PT
RFTF2-FSE-PT
With setpoint setter, step selection :
RTF2-FSE-PD2
RTF2-FSE-PD5
RFTF2-FSE-PD2
With setpoint setter, step selection, pushbutton :
RTF2-FSE-PD5T
Accessories
ET BATTERIE
BG KNOPF RTF ⁄ RFTF2 - FSE - P
®
RTF 2 - FSE or RFTF 2 - FSE are batteryless and maintenance-free radio transmitters. Energy
Energy generation by solar cell, batteryless, maintenance-free (optionally battery-operated)
EnOcean protocol, modulation ASK, 868 MHz, transmission power max. 10 mW, telegram type 4BS
see table
EnOcean Dolphin
0...+40 °C
± 0.2 K at +25 °C
0 ...100 % r. H.
± 3 % r.H. (30 ... 80 %) at +20 °C
adjustable, every 1s ⁄ 10 s ⁄ 100 s
turning angle left 0° = 0 bits
turning angle right 220° = 255 bits
Step selection: 0 to 255 bits in steps
adjustable, typically every 100 seconds,
or at any measuring value change, presence pushbutton activation, or change of turning angle
status telegram approximately every 16 minutes
indoors typically 30 - 100 m,
outdoors up to 300 m
plastic, material ABS, colour pure white (similar to RAL 9010)
98 x 106 x 32 mm (Frija 2)
wall mounting or on in-wall flush box Ø 55 mm,
base with 4-hole for mounting on vertically or horizontally installed in-wall flush boxes
–5...+55 °C
–25...+60 °C
0...90 % r.H., non-precipitating air
III (according to EN 60 730)
IP 30 (according to EN 60 529)
CE conformity according to EMC directive 2014 ⁄ 30 ⁄ EU and according to R&TTE directive 2014 ⁄ 53 ⁄ EU
Channels
Measuring Range
Temperature
1
0...+40 °C
2
0...+40 °C
2
0...+40 °C
3
0...+40 °C
3
0...+40 °C
4
0...+40 °C
3
0...+40 °C
3
0...+40 °C
4
0...+40 °C
4
0...+40 °C
Lithium battery LS 14250
Control knob (4°C...34°C) for combination with TA2-FEM
EnOcean-Profil
Humidity
EEP A5- 02 - 05
–
0...100 % r.H.
EEP A5- 04 - 01
–
EEP A5- 10 - 03
0...100 % r.H.
EEP A5- 10 - 12
–
EEP A5- 10 - 05
0...100 % r.H.
EEP A5- 10 - 10
–
EEP A5- 10 - 06
EEP A5- 10 - 04
–
0...100 % r.H.
EEP A5- 10 - 11
0...100 % r.H.
EEP A5- 10 - 01
Rev. 2017 - V12 GB
Item No.
1801- 4451-0040-040
1801- 4452-3040-040
1801- 4451-0140-040
1801- 4452-0140-040
1801- 4451-0440-040
1801- 4452-0440-040
1801- 4451-0240-040
1801- 4451-0340-040
1801- 4452-0240-040
1801- 4451-0540-040
7000- 4000-5000- 000
7000-4030- 0008- 058