Technical Data; Specified Conditions Of Use; Residual Risks - Güde GDS 250 Traduction Du Mode D'emploi D'origine

Technical Data

Artikel-Nr.
Service connection
Max. Power
Idle speed
Grinding wheel dimensions
Engine shaft diameter
Weight
Noise details
Sound pressure level L
Measured sound power level L
Guaranteed sound power level L
Measured according to
Wear ear protectors!
Measured according to EN ISO 11202:1995/AC:1997,
1)
under load, Uncertainty K=3 dB (A)
The values stated are emission values and as such do not necessarily constitute values which are safe for the
2)
workplace. Al- though there is a correlation between emission levels and environmental impact levels, whether
further precautions are neces- sary cannot be derived from this. Factors influencing the actually present envi-
ronmental impact level in the workplace include the characteristics of the work area and other noise sources,
i.e. the number of machines and other neighbouring work process- es. The permitted workplace values can like-
wise vary from country to country. This information is intended to assist the user in estimating hazards and risks.
Read and understand the operating instructions
before using the appliance. Abide by all the safety
measures stated in the service manual. Act responsib-
ly toward third parties.
In case of any doubts about connection and operati-
on refer please to our customer center

Specified Conditions Of Use

Double grinding machines for removing frays, grinding
and sharpening of steel and steel alloy workpiecesDo not
use this product in any other way as stated for normal
use. Respecting technical data and safety precau-
tions.Not observing general regulations in force and
instructions from this manual does not make the
manufacturer liable for damages.
1.
1)
pA
1)
WA
2)
WA
EN ISO 11806; 2000/14/ EG; Uncertainty K = 3 dB (A)
1) 2)

Residual risks

Danger of injury !
Never put your hands to the abrasive wheel area.
Risk of injury for fingers and hands due to rotating
abrasive wheels in case of unprofessional guiding
or supporting of the workpiece being ground.
In spite of compliance with all relevant design
regulations, dangers may still present themselves
when the machine is operated, e.g.
- work piece parts being thrown off,
- parts of damaged tools being thrown off,
- noise emissions,
- dust emissions.
ENGLISH
17
GDS 250
55123
400 V~50 Hz
750 W
2850 min
-1
250x32 mm
20 mm
44,7 kg
90,7 dB (A)
111,5 dB (A)
114 dB (A)