LaserLiner MultiClamp-Meter Pro Mode D'emploi page 15

AUTO OFF function
In order to preserve the batteries, the device switches off
automatically if left idle for 10 minutes. A signal sounds
in advance.
1 Insertion of batteries
2 AC current measurements
1.
1. Turn the rotary switch to position „200A AC".
2. Place the current clamp around a line.
3. The measured value is shown on the LC display. .
3 PEAK hold function
1.
1. Turn the rotary switch to position „200A AC" and press the
„MAX/MIN" button, to activate the PEAK function.
2. Place the current clamp around a line.
3. Switch on the consumer unit you want to measure. The
signi cant maximum value (10 ~ 282.8 A) is displayed.
The measuring device can detect fast current peaks
(<10 milliseconds).
MultiClamp-Meter Pro
1.
2.
2.
correct
2.
correct
incorrect
incorrect
15
GB