Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Normal Sounds
Your new beverage center may make sounds that your old one
didn't make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your beverage center is designed to run more efficiently to
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your beverage center to run longer than your
old one. You may also hear a pulsating or high-pitched sound
from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the beverage center.
As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your beverage center.
You may hear water running into the drain pan when the
beverage center is defrosting.
You may hear clicking sounds when the beverage center
starts or stops running.
Using the Control
The control is located behind the base grille. Lift up on the door in
the center of the grille to access the control.
For your convenience, your beverage center temperature control
is preset at the factory. When you first install your beverage center,
make sure that the control is still preset to the mid-setting as
shown.
Adjusting the Control
The mid-setting should be correct for normal usage. The control is
set correctly when beverages are as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the beverage center colder, adjust the control to the next
higher setting. To make the beverage center less cold, adjust the
control to the next lower setting.
NOTE: Adjusting the temperature control raises or lowers the
temperature in both the upper and lower zones (compartments).
BEVERAGE CENTER USE
Temperature Separator (Temperature Display)
The temperature separator displays the current temperatures
(Fahrenheit or Celsius) for the upper and lower zones
(compartments) of the beverage center. To adjust the temperature
settings, see "Adjusting the Control" earlier in this section.
Upper
Dimmer
A
B
A. Dimmer
B. Upper zone display
Beverage/Wine Racks
Remove and Replace the Top and Middle Racks
1. Pull the rack forward until it stops.
2. Lift up on the left-hand lever while pressing down on the right-
hand lever to release the rack. Pull the rack forward and lift it
up and out of the rack supports.
3. Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the beverage center.
Lower
F
D
C
C. Lower zone display
D. Fahrenheit/Celsius
A. Lever
A
7
Publicité
Table des Matières
