Adjusting The Nailing Depth - Makita FG01 Manuel D'instruction

Fuel cell
Attaching the metering valve to the fuel cell
1
2
012807
Detach the cap (in case the metering valve is provided
with the cap).
009446
Push in the front edge.
009447
Push in the rear edge until it seats.
Inserting the fuel cell
012808
Push up and pull the fuel cover to open.
1. Metering valve
2. Cap
7
012809
Insert the fuel cell directing the jet nozzle of the metering
valve toward the adaptor.
009450
Insert the jet nozzle into the small hole of the adapter
properly.
012811
Put the fuel cover over the metering valve and push it
down to latch.

Adjusting the nailing depth

CAUTION:
Remove the fuel cell, the battery cartridge and nails
•
before adjusting the depth of nailing.
B
012812
To get shallower depth, turn the adjuster to A direction
shown in the figure. To get deeper depth, turn the
adjuster to B direction. Do not turn the adjuster too much,
or the contact element may come off from the adjuster, or
1. Jet nozzle
1
1. Adjuster
1
A