Adjusting The Nailing Depth - Makita GN01 Manuel D'instruction

Push in the front edge.
Push in the rear edge until it seats.
Inserting the fuel cell
Push up and pull the fuel cover to open.
► 1. Jet nozzle
Insert the fuel cell directing the jet nozzle of the meter-
ing valve toward the adaptor.
Insert the jet nozzle into the small hole of the adapter
properly.
Put the fuel cover over the metering valve and push it
down to latch.

Adjusting the nailing depth

CAUTION:
• Remove the fuel cell, the battery cartridge and
nails before adjusting the depth of nailing.
1
► 1. Adjuster
To get shallower depth, turn the adjuster to right direc-
tion as shown in the figure. To get deeper depth, turn
the adjuster to left direction.
Do not turn the adjuster too much, or the adjuster may
get stuck.
7 ENGLISH
1