Connecting The Air Hose; Unloading The Nailer - Makita AN923 Manuel D'instruction

011695
Load nails so that they get parallel to the driver guide.
007008
Pull the pusher lever to the rear to engage the pusher to
the last nail.

Unloading the nailer

3
007009
Pull the pusher lever to the rear. Return the pusher lever
back while keeping the pusher depressed to disengage it
from the strip of nails.
Depress the nail stopper and remove the strip of nails
from the magazine.
007010
1. Pusher
1
1. Pusher lever
1
2. Depress
3. Return
2
1. Nail stopper
1

Connecting the air hose

1
007011
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
Make sure all safety systems are in working order
•
before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
007012
2
007013
2. Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you
•
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
However when the tool is set to the "Intermittent
•
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
6
1. Air socket
2
2. Air fitting