Krups i Prep & Cook XL Serie Mode D'emploi page 111

PROBLEMS
Leak through the bowl
spindle or by the XL bottom
accessory.
The blades do not rotate
easily.
Smell from motor.
"STOP" is displayed.
"SECU" is displayed.
"SECU" is displayed + red
indicator light is flashing.
"Err1" is displayed.
+ red indicator light is
flashing.
"Err2" is displayed.
"Err3" is displayed.
"Err4" is displayed.
Displays «Err8»
"ntc1" is displayed.
+ red indicator light is
flashing.
"ntc2" is displayed.
+ red indicator light is
flashing.
Safety indicator display (C4)
The safety lock on the
lid remained active (rod
extended) and prevents the
lid from locking.
Connection problem
Is your appliance still not working?
Contact an approved service centre (see list in service booklet).
CAUSES
The bowl seal is not correctly
positioned.
The bowl seal is damaged.
The locking ring (D6) is not locked
correctly.
Pieces of food that are too big or too
hard are blocking it from rotating.
On using the appliance for the first
time, or in the event of overload of the
motor caused by too large a quantity
of ingredients or by pieces that are too
hard or too big.
The appliance has detected too many
vibrations and has changed to the
safety mode.
Motor overload caused by too many
ingredients or pieces which are too
hard or too large or overuse without
sufficient cooling down time.
Overheating of temperature sensors.
The heating element is not working.
Electronic fault.
Speed fault.
Communication fault with chopper
electronic card.
Default security sensor lock.
Temperature sensor 1 is no longer
working.
Temperature sensor 2 is no longer
working.
Improper locking of the bowl or lid
The lid is locked on the bowl in the
"cooking without a lid" mode
The appliance was turned off as a
recipe was in progress by toggling the
I/O switch to the "O" position or was
simply unplugged as a recipe was in
progress.
SOLUTIONS
Position the seal correctly.
Contact an approved service centre.
Lock the ring correctly (D6).
Reduce the size or quantity of the ingredients
processed. Add some liquid.
Allow the motor to cool down (about 30
minutes) and reduce the number of ingredients
in the bowl.
Check that you are using the right speed
and that you are using the recommended
accessory.
Allow the motor to cool down (about 30
minutes) and reduce the number of ingredients
in the bowl.
Contact an approved service centre.
Check that the power pins under the bowl are
not clogged with food. If this is the case, clean
them and try again.
If that still does not work, contact an
approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Prior to operating the appliance, check that the
bowl is properly locked on the motor unit and
that the lid is properly locked on the bowl. If the
problem persists, contact an authorised centre.
Unlock the lid prior to launching the cooking
program. If the problem persists, contact an
authorised centre.
Simply toggle the I/O switch to the "I" position
to reset the food processor, along with the
safety lock on the lid; the rod will automatically
return to its original position. You may now lock
the lid.
See the app guide
104