Chicco oasys 1 Mode D'emploi page 26

between the base of the Car seat and
the vehicle's seat, inserting it in the
lower red belt guides (R) (Fig. 9A - Fig.
9B).
WARNING! Always make sure not to tangle
the belt during this operation.
4. Introduce the diagonal belt section in
the upper red belt guides (Q) located in
the upper part of the Car seat (Fig. 10),
sliding it without tangling it.
WARNING! Always make sure that the belt is
properly introduced inside the belt guides.
5. Pull the diagonal safety belt, starting
from the buckle towards the reel (a-b),
to properly tension the belt (Fig. 11).
6. Complete the installation, securing first
the belt-lock clamp (O) and then the
tensioner (K) (Fig. 12).
7. Check that the Car seat is properly
installed (Fig. 13).
WARNINGS FOR THE PROPER
INSTALLATION OF THE CAR SEAT
WARNING! Do not compromise safety,
ALWAYS check
installation:
• the vehicle's belt is not tangled in any
point.
• The belt is well tensioned in all areas.
• At the end of the operations, the Car
seat must adhere well to the vehicle's
seat; otherwise, repeat the installation
procedure.
SEATING THE CHILD IN THE CHILD CAR
SEAT
• Before sitting your child in the child
Car seat, press the harness adjustment
button (D) and, at the same time, hold
the two child Car seat harnesses under
the shoulder straps, and pull them in your
direction to slacken them (Fig. 14).
• Unfasten the buckle (F) of the child Car
seat harnesses by pressing the red button
(Fig. 15), and pull the harnesses in an
outward direction. Now the child can be
the following
placed in the child Car seat (Fig. 16).
• Position the crotch strap correctly, take
the harnesses, overlap the two buckle
straps (Fig. 17A) and push them together
firmly inside the buckle slot, until a click is
heard (Fig. 17B).
HOW TO REMOVE THE CHILD FROM THE
CHILD CAR SEAT
To remove the child from the child Car seat,
press the red button on the buckle (F) and
release the restraint harness.
ADJUSTING THE HEADREST AND
HARNESSES
The height of the headrest and restraint
harnesses can be simultaneously adjusted
to 6 positions by pressing the button
located at the rear (M).
WARNING! To adjust them correctly, the
headrest must be fitted so as to allow that
the harnesses come out from the backrest at
the height of the child's shoulders (Fig. 18).
To adjust the height, press the adjustment
button (M), located at the rear of the
after
backrest (Fig. 19) and, at the same time,
slide the headrest until the desired position
is reached (Fig. 20); now release the button
and ease the headrest until a click is heard,
indicating that it is locked correctly into
position.
To tighten the restraint harnesses of the
child Car seat, pull the adjustment strap
of the restraint harnesses (E) (Fig. 21), until
they are correctly fitted to the child's body.
After tightening the restraint harnesses,
hold the shoulder straps and pull them in a
downward direction to adjust the harnesses
to the child's body.
WARNING!
harnesses around the child: if you can insert
one finger between the harness and your
child's shoulders, it means that they are
tightened correctly
WARNING! Check that the harness straps are
not twisted.
26
Do not over-tighten the