Overheating Protection - ESAB Origo Arc 410c Manuel D'instructions

GB
6.7.2 A11 panel
1. ARC FORCE knob
2. HOT START knob
3. Current setting knob
4. Method selector switch:
Arc Air Gouging, MMA, TIG
6.7.3 A12 panel
1. ARC FORCE knob
2. HOT START knob
3. Current setting knob
4. Method selector switch:
Arc Air Gouging, MMA, TIG
5. Local / wireless remote
control switch
6. A/V measurement switch
7. Display
6.8

Overheating protection

If the internal temperature becomes too high, the welding is interrupted and disabled.
This state is indicated by permanent lighting of the orange indicating lamp on the
front of the unit. It resets automatically when the temperature falls down.
Arce
- - 10 - -