Operation; Switching On The Voltage Converter; Switching On The Voltage Converter Via Bluetooth® Remote Control Module; Sleep Mode" (Power Save Function) - AEG SW 600 W Mode D'emploi

36 www.aeg-automotive.com

OPERATION

Mode Meaning

"Sleep Mode" (power save function)

• 230 V output will only be powered if the
voltage converter is connected to the 230 V
mains (see "Mains priority circuit").
• uSB ports will still to be powered.
• The voltage converter can be operated via
app (requires Bluetooth® remote control
module).
230 V output and USB ports are always
powered.

Switching on the voltage converter

1. Press the button [19] for approx. 3 seconds
to switch on the voltage converter. The voltage
converter is now in "Sleep Mode" (power save
function). The green LEDs
on the voltage converter and remote control
module are lit.
2. Press the button [21] to exit "Sleep Mode"
(power save function). The green LED [23] goes
out. The voltage converter is ready to use.
The display shows the power currently being drawn
in volt. use the MODE [20] button to change the
display.
The display switches off after approx. 60 seconds.
Press the MODE [20] button to reactivate the
display.
and [22, 23]
Switching on the voltage converter via Blue-
tooth® remote control module
1. Verify the remote control module is connected.
2. Press the button [19] on the remote control
module for approx. 3 seconds to switch on the
voltage converter. The voltage converter is ready
to use. The green LED
The display shows the power currently being drawn
in volt. use the MODE [20] button to change the
display (see "Changing the display").
The display switches off after approx. 60 seconds.
Press the MODE [20] button to reactivate the
display.
"Sleep Mode" (power save function)
1. Press the button [21] button to activate
"Sleep Mode" (power save function).
2. Press the button [21] again to exit "Sleep
Mode" (power save function).

Switching off the voltage converter

To switch off the voltage converter, press the
button [19] for 3 seconds. The voltage converter
switches off and all displays go off.

Changing the display

When pressing the MODE [20] button whilst
operating the voltage converter, the LED display will
switch between watt, volt and error code. If no error
is present, it will show "AA".
[22] will light up.