Connectable Power Sources; Connectable Devices; Intended Installation Locations - AEG SW 600 W Mode D'emploi

Connectable power sources

Note:
Connecting to power sources with a different
output voltage and less capacity is prohibited and
improper.
The voltage converter is intended for connection to
the following power sources:
Model
12 V direct voltage
recommended
battery capacity
60
in Ah:
230 V mains
2)
Principle of mains priority circuit:
2)
The voltage converter can additionally be con-
nected to a 230 V mains supply. When connecting
the voltage converter to a 230 V mains supply
in addition to the 12 V power supply, the mains
priority circuit automatically supplies the connected
consumers via the 230 V power source. If the mains
priority circuit is active, the 12 V power supply will
not be used.
The voltage converter is not suitable for use as an
uninterruptible power supply (UPS)!
230 V sockets in caravan/recreational vehicle
x x x x
100 150 200
- - x x
CEE supply Power
socket distribution

Connectable devices

The voltage converter supplies pure sinusoidal volt-
age. To prevent consequential loss, please verify the
device to be powered is suitable.
The maximum total power rating including starting
current of the connected devices must not exceed
the power output of the voltage converter (see
"Technical data").

Intended installation locations

The voltage converter is intended for installation in:
•
Cars and lorries
x
•
Caravans
•
300
Boats
The voltage converter is not intended to be placed:
•
x
near heat sources (heaters, direct sunlight),
flammable materials, a battery compartment or a
starter battery,
•
in damp locations or locations exposed to drip-
ping or splashing water,
•
in explosive environments.
English 27