Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
reaches all the slots of the combustion
en
chamber.
•••10.1.5. Lift the combustion chamber
it
from the back to empty as much water
de
as possible from inside the chamber (this
operation must be carried out with the
es
utmost attention to avoid personal harm
fr
or damaging the heater) (Pic. 14).
•••10.1.6. Reassemble the heater performing
nl
the sequence of operations in the opposite
pt
order, replacing the gaskets with original
spare parts.
da
NOTE:
BEFORE
fi
HEATER BACK ON, MAKE SURE AS
MUCH
WATER
no
BEEN ELIMINATED FROM INSIDE THE
COMBUSTION CHAMBER TO AVOID
sv
SERIOUS DAMAGE.
pl
►►10.2. CLEANING THE FAN:
ru
Use compressed air for routine cleaning
cs
of the fan, blowing the air through the rear
grille.
hu
sl
tr
hr
11. PREVENTIVE MAINTENANCE SCHEDULE
lt
WARNING: BEFORE PERFORMING ANY MAINTENANCE OR REPAIRS,
lv
DISCONNECT THE POWER CABLE AND MAKE SURE THAT THE HEATER IS
et
ro
COMPONENT
sk
Safety
bg
thermostat
Nozzle
uk
bs
Electrical system Yearly check and/or when
el
Fan
zh
Motor
Fuel pump
Combustion
chamber
SWITCHING
THE
AS
POSSIBLE
HAS
MAINTENANCE
FREQUENCY
Yearly check and/or when
required
Replace yearly and/or when
required
required
Yearly cleaning and/or when
required
Yearly check and/or when
required
Yearly check and/or when
required
Yearly check and/or when
required
►►10.3. CLEANING THE BURNER:
IMPORTANT:
be carried out by contacting the
authorised technical support centre.
Read and understand the specific manual
to clean the burner.
COLD.
Contact the authorised technical
support centre
Contact the authorised technical
support centre
Contact the authorised technical
support centre
Contact the authorised technical
support centre
Contact the authorised technical
support centre
Contact the authorised technical
support centre
Contact the authorised technical
support centre
This
operation
MAINTENANCE
PROCEDURE
can
Publicité
Table des Matières
