Mitsubishi Electric CITY MULTI PLFY-P-VEM-E Série Mode D'emploi page 14

1
3
When equipped with the wireless remote controller
5 6
A
B
C
E
G
H
G
F
4-directional
1 pattern: initial setting
Blowout direction
patterns
2-directional
6 patterns:
2 air outlet fully closed
Blowout direction
patterns
<Hook is in the raised position>
2
4
7 8
2
2
D
B
F
1
3-directional
4 patterns:
one air outlet fully closed
Table 1
<Hook is in the lowered position>
Accessory name Q'ty
1 Grille
2 Installation gauge
3 Screw (4 × 16)
4 i-see Sensor corner panel
5 Wireless remote controller
6 Remote controller holder
7 LR6 AA batteries
8 3.5 × 16 tapping screws
2
unit relative to the ceiling surface. If the main unit is not properly positioned relative
to the ceiling surface, it may allow air leaks or cause condensation to collect.
860 × 860 - 910 × 910
adhere to this range.
A Main unit
B Ceiling surface
C Installation gauge 2 (inserted into the main unit)
D Ceiling opening dimensions
* Do not unlatch the hook for the intake grille.
from the grille as indicated by the arrows 2.
arrow 1
A Intake grille
B Grille 1
C Intake grille levers
D Grille hook
E Hole for the grille's hook
F Corner panel
G Screw
H Detail
For this grille the discharge direction is available in 11 patterns. Also, by setting the
and speed. Select the required settings from the Table 1 according to the location
in which you want to install the unit. (More than two directions must be selected.)
1) Decide on the discharge direction pattern.
2) Be sure to set the switch on the control board to the appropriate settings according
to the number of air outlets and the height of the ceiling on which the main unit
will be installed.
Note:
Remarks
1
950 × 950 (mm)
1
(Divided into 4 parts)
1
For PLP-6EAE, PLP-6EALE, PLP-6EALME
1
For PLP-6EAE, PLP-6EALE, PLP-6EALME
1 For PLP-6EALM, PLP-6EALME
Included when equipped with the wire-
1
less remote controller.
Included when equipped with the wire-
2
less remote controller.
Included when equipped with the wire-
2
less remote controller.
1 to open the intake grille.