Mitsubishi Electric CITY MULTI PLFY-P-VEM-E Série Mode D'emploi page 7

1
A
[ ]
B
2
[ ]
A
B
E
3
[ ]
F
4
[ ]
G
H
J
I
5
[ ]
A
A A
A
K
J
N
Secure the remote controller cable and indoor-outdoor
connection cable with the cable strap.
If only one indoor-outdoor connection cable is connected,
secure it using the cable strap according to the dimen-
sions marked on the diagram.
C
D
A
A-A
Arrange the cables so that the
electrical wiring service panel is
not lifted up.
indoor-outdoor connection
Use round solderless
terminals with insulating
sleeves for the indoor-
outdoor connection cable.
1. Loosen the two screws securing the electrical wiring service panel, and then turn
the electrical wiring service panel. [Fig. 4-1 1]
2. Loosen the one screw securing the electrical wiring service panel at the cable
entry (remote controller cable and indoor-outdoor connection cable), and then
turn the service panel to the position shown in the diagram. [Fig. 4-1 2]
3. Loosen the two screws securing the electrical box cover, then slide the electrical
box cover. [Fig. 4-1 3]
4. Pass and wire the power cable and the earth cable through the wiring entries
given in the diagram. [Fig. 4-1 4]
5. Pass and wire the remote controller cable and the indoor - outdoor connection
cable through the wiring entries given in the diagram. [Fig. 4-1 5, Fig. 4-2, Fig. 4-3]
connection cable into the electrical box.
Screw tightening torque
Remote controller terminal board
Indoor-outdoor connection terminal board
Power terminal board
Earth cable
during servicing (approx. 50 to 100 mm).
A
Electrical wiring service panel
B
Screw
C
Electrical box cover
D
Temporary hook for electrical box cover
E
Screw
F
Slide direction of the electrical box cover
G
Entry for power cable
H
Secure with the cable strap.
I
Earth cable
J
Power terminal
K
Entry for wired remote controller and indoor-outdoor connection cable
L
Drain Pan
M
Length of the cable not covered by the indoor - outdoor connection cable sheath.
N
Secure with the cable strap
O
Wired remote controller terminal
P
Indoor - outdoor connection terminal
Caution:
MA remote controller terminal board
* Terminals 1 and 2 are non-polar.
P
O
Be sure to connect the wires (0.3 mm²) of
the remote controller cable at the locations
marked on the diagram.
Tightening torque (N·m)
1.2 ± 0.1
1.2 ± 0.1
1.6 ± 0.1
1.6 ± 0.1
7