Electric Fan Application And Connections; Installation Of A Room Temperature Probe - Palazzetti ECOFIRE DA INSERIMENTO Notice D'installation

must be connected to the second room.
It is prohibited to connect air intake B to kitchens,
bathrooms or bedrooms.
In this type of installation the external air intake V
is not necessary.
)
Depending on the method adopted, we recommend
you mark the position of the air intakes on the
¿UHSODFH FODGGLQJ DQG RQ WKH RXWVLGH ZDOO GXULQJ
the trial assembly.
6.3 ELECTRIC FAN APPLICATION AND
CONNECTIONS
)
2QO\ IRU WKH GXFWHG YHUVLRQ
6.3.1 Preparing the ducts
+ROG WKH WZR HQGV RI WKH ÀH[LEOH ‘  SLSH DQG
pull it until it is about 150 cm long.
While pulling the pipe, turn it from both ends in
opposite directions.
Cut the pipe with a knife or scissors at the required
length.
6.3.2 Air fan
The air fan (1) is located in the lower rear part of
the stove (Fig. 6.3.2).
6.3.3 Connecting the fan
&RQQHFW WKH ÀH[LEOH SLSHV WR WKH SLSH ¿WWLQJV RI WKH
HOHFWULF IDQ ER[ DQG ¿[ WKHP ZLWK WKH FODPSV DIWHU
having sealed them with silicone.
Apply mortar between the pipes and the wall.
7KH DLU VXFWLRQ FLUFXLW WR WKH IDQ PXVW DOZD\V EH
SHUIHFWO\ VHDOHG
Failing this, when the fan is started, it will create a
strong vacuum which will draw back smoke from
the brazier grille with consequent exit of smoke
through the hot air outlets.

6.3.4 Installation of a room temperature probe

DUCTED ECOFIRE FOR BUILDING IN
The installation of the probe must be effected on
WKH ÀH[LEOH DOXPLQLXP SLSH ZKLFK OHDGV WKH DPELHQW
air at 30 cm from the inlet of the convection fan.
For installation, follow the following steps (Fig.
6.3.3):
1) unscrew the probe holder (a) from the rear of
the stove
 SLHUFH RQH RI WKH WZR ÀH[LEOH SLSHV RI WKH DLU
intake of the fan (b)
3) reassemble the probe with the probe holder, on
WKH SLSH DV VKRZQ LQ WKH ¿JXUH
cod. 00 477 1480 - 12/2012 - Palazzetti - PN - Italy
INSTALLATION
A
C
1
a
b
B
Fig. 6.2.3
Fig. 6.3.1
Fig. 6.3.2
Fig. 6.3.3
49/164