Dometic SINEPOWER DSP 612 Instructions De Montage page 15

SinePower
➤ Check that the inverter is sufficiently ventilated and that the ventilation grilles are
unimpeded.
➤ Wait 5 – 10 minutes and switch the inverter on again without any electric
consumers.
9.3 Switching to energy-saving mode
I
NOTE
• The inverter automatically switches to normal operation when a load
over 45 W is connected.
• If an external switch is connected, you cannot change the energy
saving mode.
Activating energy saving mode
➤ If necessary, switch the inverter off.
➤ Press the on/off button (fig. 3 1) of the remote control until the status LED
(fig. 3 2) of the remote control has flashed six times.
✓ Then the status LED (fig. 3 2) of the remote control flashes every 5 seconds.
✓ Energy saving mode is activated.
Deactivating energy saving mode
➤ Switch the inverter off.
➤ Press the on/off button (fig. 3 1) of the remote control until the status LED
(fig. 3 2) of the remote control goes on constantly.
Before the status LED goes on constantly, it indicates that energy saving mode
will be switched off by an interval of flashing four times followed by flashing six
times.
✓ Normal mode is activated.
EN
Using the inverter
15