Maintenance And Care; Carburettor Adjustment - Shindaiwa T335TS Manuel D'utilisation

Replacing fuel filter

Carburettor adjustment

YOU MAY ADJUST THE IDLE SPEED ONLY by turning the idle speed adjustment screw(T).
During carburettor adjustment, the cutting attachment may move. Pay utmost attention and care to the cutting at-
tachment so as not to get injured by the moving cutter.
When carburettor adjustment is completed, the cutting attachment should not move at idle speed, otherwise serious
personal injury may result.
You must NOT carry out any Carburettor adjustment, other than the idle speed. All other adjustments MUST be per-
formed by an authorized service dealer, or serious personal injury may result due to malfunction of the engine.
When there is trouble with the carburettor, contact an authorized service dealer.

Maintenance and care

1. Use a piece of metal wire or the like to pick up fuel filter (A)
through fuel tank opening.
2. Pull old filter from fuel line (B).
3. Install new fuel filter.
If filter is excessive dirty or no longer fits properly, replace it.
WARNING
CAUTION
Every unit is test run at the factory and the carburettor is fine
tuned for maximum performance.
Before adjusting carburettor, clean or replace air filter, start en-
gine and run several minutes to bring it to operating temperature.
1. Start engine and turn "idle" speed adjustment screw clock-
wise until the cutting attachment begins to turn, then turn the
screw anticlockwise until the cutting attachment stops turn-
ing. Turn screw anticlockwise an additional 1/4 turn.
2. Accelerate to full throttle for 2 to 3 seconds to clear excess
fuel from engine then return to idle. Accelerate to full throttle
to check for smooth transition from idle to full throttle.
∗ The length of inner cable can be adjusted for proper pulling by
opening cover (A) and resetting flange of throttle cable (B) into
a suitable groove on the left or right.
C: Shaft tube side
NOTE
When the carburettor cannot be adjusted properly with the idle
speed adjustment screw (T), you must contact an authorized
service dealer.
21
NOTE
D: Engine side