Maintenance And Care; General Maintenance; Carburettor Adjustment - Shindaiwa AH243S-LW Manuel D'utilisation

Maintenance and care

Maintenance and care
If you have any questions or problems, please contact your dealer.

General maintenance

IMPORTANT
Maintenance, replacement, or repair of emission control devices and system may be performed by any repair establishment or
individual. However, warranty repairs must be performed by a dealer or service center authorized by YAMABIKO CORPORA-
TION and use of parts that are not equivalent in performance and durability to authorized parts may impair the effectiveness of
the emission control system and may have a bearing on the outcome of the warranty claim.
Non-standard accessories, cutting attachment, or replacement parts may not operate properly with your unit and
may cause damage and lead to personal injury.
Before performing any maintenance, repair, or cleaning work on the unit, make sure the engine and cutting attach-
ment are completely stopped. Disconnect the spark plug wire before performing service or maintenance.
Operating the engine without a silencer, or with a silencer that is damaged or improperly installed, can increase en-
gine noise sufficiently to cause hearing loss.

Carburettor adjustment

YOU MAY ADJUST THE IDLE SPEED ONLY by turning the idle speed adjustment screw(T).
During carburettor adjustment, the cutting attachment may move. Pay utmost attention and care to the cutting at-
tachment so as not to get injured by the moving cutter.
When carburettor adjustment is completed, the cutting attachment should not move at idle speed, otherwise serious
personal injury may result.
You must NOT carry out any Carburettor adjustment, other than the idle speed. All other adjustments MUST be per-
formed by an authorized service dealer, or serious personal injury may result due to malfunction of the engine.
When there is trouble with the carburettor, contact an authorized service dealer.
Maintenance and care
WARNING
Silencer
This unit must never be operated with a faulty or missing spark
arrester or silencer. Make sure the silencer is well secured and
in good condition. A worn or damaged silencer is a fire hazard
and may also cause hearing loss.
Spark plug
Keep the spark plug and wore connections tight and clean.
Fasteners
Make sure nuts, bolts, and screw (except carburettor adjusting
screws) are tight.
WARNING
CAUTION
24