Maintenance And Care; Servicing Guidelines - Shindaiwa T410TS Manuel D'utilisation

Observe the following precautions when checking and maintaining your product after use:
Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.

Servicing guidelines

Area
Air filter
Fuel filter
Spark plug
Carburettor
Cooling system
Silencer
Silencer
Drive shaft
Angle transmission
Starter
Cut off knife
Fuel system
Screws, bolts and nuts
* Or 50 hours, whichever occurs first. ** Or 100 hours, whichever occurs first.
Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.

Maintenance and care

If you have any questions or problems, please contact your dealer.
Cleaning air filter
IMPORTANT
Maintenance
Clean/Replace
Inspect/Clean/Replace
Inspect/Clean/Adjust/Replace
Adjust/Replace and adjust
Inspect/Clean
Inspect/Tighten
Clean
Grease
Grease
Inspect
Inspect/Clean
Inspect
Inspect, Tighten/Replace
IMPORTANT
Maintenance and care
Maintenance and care
WARNING
Page
19
20
21
20
20
21
21
21
22
-
-
20
-
1. Close choke. Loosen screw and remove air cleaner cover
(A).
2. Remove air filter (B) (air filter is located inside air cleaner
cover).
3. Brush dirt from filter or clean with compressed air.
4. Reinstall filter.
5. Reinstall cover and tighten screw.
19
Before use Monthly
•
•
•
•
•
•
•
•
•
•
•**
•**
•*