Troubleshooting; Specifications - Sony CDP-XA50ES Mode D'emploi

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT/
PHONE LEVEL control.
The CD does not play.
/There's no CD inside the player. Insert a CD.
/Use the stabiliser.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 26).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 26).
The recording level has changed.
/When you connect the amplifier via the
VARIABLE LINE OUT jacks, the recording level
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
Additional Information Additional Information

Specifications

Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ±0.3 dB
Dynamic range More than 100 dB
Harmonic distortion CDP-XA50ES: Less than 0.0017 %
CDP-XA30ES: Less than 0.0018 %
Outputs
Jack Maximum
type output
level
LINE OUT
Phono
2 V
(FIXED) jacks
(at 50 kilohms)
LINE OUT
Phono
2 V
(VARIABLE) jacks
(at 50 kilohms)
DIGITAL
Optical
–18 dBm
OUT output
(OPTICAL)
connector
DIGITAL Coaxial
0.5 Vp-p
OUT
output
(75 ohms)
(COAXIAL)
connector
PHONES
Stereo
28 mW
phone
jack
General
Power requirements
Where purchased Power requirements
Europe 220 V – 230 V AC, 50/60 Hz
Other countries CDP-XA50ES 220 V – 230 V AC, 50/60 Hz
CDP-XA30ES 110 V – 120 V or 220 V – 240 V
Power consumption CDP-XA50ES: 20 W
CDP-XA30ES: 20 W
CDP-XA50ES: 430 × 125 × 375 mm
Dimensions (approx.)
(17 × 5 × 14 7/8 in.) incl. projecting
(w/h/d)
parts
CDP-XA30ES: 430 × 125 × 350 mm
(17 × 5 × 13 7/8 in.) incl. projecting
parts
Mass (approx.)
CDP-XA50ES: 15.2 kg (33 lbs 8 oz)
CDP-XA30ES: 9.0 kg (19 lbs 13 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Stabiliser (1)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Over 50 kilohms
Wave length: 660 nm
75 ohms
32 ohms
AC, adjustable, 50/60 Hz
EN
27