Sony CDP-XA50ES Mode D'emploi page 15

4
Repeat Steps 2 and 3 to programme the tracks in
the order you want.
5
Press · to start Programme Play.
To cancel Programme Play
Press PLAY MODE three times.
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
The programme remains even after the Programme
Play ends
When you press ·, you can play the same programme
again.
Notes
• "– – . – –" appears instead of the total playing time in the
display when it exceeds 100 minutes.
• "FULL" appears in the display when you try to add a track
to a programme which already contains 24 tracks.
Creating a programme using the remote
1
Press PROGRAM before you start playing.
"PROGRAM" appears in the display.
2
Press number buttons of the tracks you want to
programme in the order you want.
Example: To programme the tracks 2, 8 and 5
Press number buttons in the order 2, 8
and 5.
PROGRAM
MIN
STEP
Last programmed
Total playing time Programmed
track
Playing order
To select a track with a number over 10
Use >10 button (see page 11).
If you've made a mistake
Press CLEAR, then press the correct track number.
2 5
SEC
8
tracks
3
Press · to start Programme Play.
To cancel Programme Play
Press CONTINUE.
You can check the total playing time while
programming using the remote (Programme Edit)
To select a track, press = or + and check the total
playing time. Then press PROGRAM to confirm your
selection.
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
The programme remains even after the Programme
Play ends
When you press ·, you can play the same programme
again.
Notes
• "– – . – –" appears instead of the total playing time in the
display when it exceeds 100 minutes.
• "FULL" appears in the display when you try to add a track
to a programme which already contains 24 tracks.
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK.
Each time you press this button, the display shows the
track number in the programmed order. After the last
track in the programme, the display shows "End" and
returns to the original display. If you check the order
after you start playing, the display shows only the
remaining track numbers.
Playing CDs
15
EN