Making Connections; Speaker Connection - Sony MEX-N7300BD Mode D'emploi

Making connections

If you have a power antenna (aerial) without
a relay box, connecting this unit with the
supplied power supply lead  may damage
the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
 To the car's power connector
continuous power
12
supply
power antenna (aerial)
13 /power amplifier
control (REM OUT)
switched illumination
14
power supply
switched power
15
supply
16 ground (earth)
36
GB
 Purple
Purple/black

striped
 Gray
Gray/black

striped
 White
White/black

striped
 Green
Green/black

striped
Yellow
Blue/white
striped
Orange/
white striped
Red
Black
Subwoofer Easy Connection
You can use a subwoofer without a power
amplifier when it is connected to a rear
speaker lead.
Notes
• Preparation of the rear speaker leads is required.
• Use a subwoofer with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Memory hold connection
When the yellow power supply lead is
connected, power will always be supplied to
the memory circuit even when the ignition
switch is turned off.

Speaker connection

• Before connecting the speakers, turn the
unit off.
• Use speakers with an impedance of 4 Ω to
8 Ω, and with adequate power handling
capacities to avoid damage.
Power connection diagram
Check your car's auxiliary power connector,
and match the connections of leads
correctly depending on the car.
Auxiliary power connector
Front speaker
Subwoofer