Toto Connelly TB221S Manuel D'installation Et D'utilisation page 4

INSTALLATION PROCEDURE - Spout
3. Orient spout assembly as shown
and lower onto exposed portion of
diverter valve.
Use hex key to fasten spout to valve
with provided set screw. Tighten as
needed.
INSTALLATION PROCEDURE - Handles
*Actual product may vary in
appearance depending on model.
1. Orient handle assembly and lower
onto the exposed portion of valve
until engaged. Use hex key to
fasten spout to valve with provided
set screw. Tighten as needed.
Repeat for other handle assembly.
NOTE: If handles do not line up
exactly as desired, remove handle
from valve and reinstall one (1)
notch over (on valve).
4
Side View