Safety Instructions; Connection To The Mains - Whirlpool ADN203 C Mode D'emploi

CAREFULLY READ THE INSTRUCTION MANUAL. If instructions are not followed,
there is a risk of injury, damage of the appliance and loss of the right to free warranty
service.
The Manufacturer shall not be held liable for damage arising from the failure to observe
the instructions contained in this manual.
We recommend to keep the Instruction manual the whole time you have the appliance.
When you sell the appliance pass the Instruction manual to the new owner of the
appliance.
Do not cover the ventilation holes at the top and on the sides of the
–
appliance.
Do not use electrical appliances inside the food storage compartments of the
–
appliance, unless they are of the type recommended by the manufacturer.
If the supply cord is damaged it must be replaced by the manufacturer,
–
manufacturer service agent or a similarly qualified person, in order to avoid a
hazard.
Disposal of the appliance should be according to national rules.
–
Do not damage the appliance refrigeration system. It contains the refrigerant
–
gas R600a. If the refrigeration system is damaged:
Do not use any open flame.
•
Avoid sparks ― do not turn on any electrical appliances or lighting
•
fixtures.
Immediately ventilate the room.
•
Air the room in which the appliance is placed for a few minutes (the
•
size of the room for a product containing isobuthane / R600a must
be at least 4 m
Once the appliance is unpacked, make sure that it is complete, that the body
•
and the electrical cord aren't damaged. It is forbidden to use a technically
damaged appliance.

CONNECTION TO THE MAINS

The appliance should only be connected to an earthed socket installed in
–
accordance with the regulations. Make sure that the supply voltage
corresponds with the voltage marked on the rating label. This product
complies with all binding CE labelling directives. The earthed electrical socket

SAFETY INSTRUCTIONS

) to avoid damage to the cooling system.
3
GB
3