UNPACKING
Carefully remove this unit and accessories from the box. You should find the unit itself and the following accessories.
Remote control
CDX-596
OPEN/
SYNCHRO
DIMMER
CLOSE
TEXT/
SPACE
TIME
PEAK
TAPE
CLEAR
PROG
1
2
3
4
5
6
7
8
9
+
0
I0
INDEX
–
+
OUTPUT LEVEL
REPEAT
RANDOM
NOTES ABOUT THE REMOTE CONTROL
Battery installation
1. Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of the
arrow.
2. Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery
compartment.
3. Close the battery compartment cover.
Battery replacement
If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use only AA, R6, UM-3 batteries for replacement.
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote control will not be used for
an extended period of time.
● If batteries leak, dispose of them immediately. Avoid touching
the leaked material or letting it come in contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
4
E-
CDX-496
CDX-396
OPEN/
SYNCHRO
DIMMER
SYNCHRO
DIMMER
CLOSE
SPACE
SPACE
TIME
PEAK
TAPE
CLEAR
TAPE
CLEAR
PROG
1
1
2
3
4
4
5
6
7
7
8
9
+
0
0
I0
INDEX
–
+
OUTPUT LEVEL
REPEAT
REPEAT
RANDOM
1
3
2
RCA pin cable
OPEN/
CLOSE
TIME
PEAK
PROG
2
3
5
6
8
9
+
I0
INDEX
Battery (size AA, R6, UM-3) x 2
RANDOM
Remote control operation range
CDX-596, CDX-496
Notes
● There should be no large obstacles between the remote control
and the main unit.
● If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type fluorescent lamp etc.), the
remote control might not work properly. In this case,
reposition the main unit to avoid direct lighting.
CDX-396
Remote control
sensor
Within approximately
6 m