Tips; Screen Care; Image Persistence; No Power - Telefunken TF2636X880LU Mode D'emploi

Tips

Screen Care

Clean the screen with a slightly damp, soft cloth. Do
not use abrasive solvents as they may damage the
coating layer of the TV screen.
For your safety, unplug the mains plug when cleaning
the set. When moving the TV, hold it properly from
the bottom part.

Image Persistence

Please note that ghosting may occur while displaying
a persistent image. LCD TVs' image persistence may
disappear after a short time. Try turning off the TV
for a while.
To avoid this, do not leave the screen in still picture
for extended periods.

No Power

If your TV system has no power, please check the
main power cable and connection to the mains
socket outlet.

Poor Picture

Have you selected the correct TV system? Is your TV
set or house aerial located too close to a non-earthed
audio equipment or neon lights, etc.?
Mountains or high buildings can cause double pictures
or ghost images. Sometimes you can improve the
picture quality by changing the direction of the
aerial.
Is the picture or teletext unrecognisable? Check if you
have entered the correct frequency. Please retune
the channels.
The picture quality may degrade when two peripherals
are connected to the TV at the same time. In such a
case, disconnect one of the peripherals.

No Picture

Is the aerial connected properly? Are the plugs
connected tightly to the aerial socket? Is the aerial
cable damaged? Are suitable plugs used to connect
the aerial? If you are in doubt, consult your dealer.
No Picture means that your TV is not receiving a
transmission. Have you selected the correct button
on the remote control? Try once more.
Also make sure the correct input source has been
selected.

Sound

You can not hear any sound. Did you perhaps interrupt
the sound, pressing the
Sound is coming from only one of the speakers. Is the
balance set to one extreme? See Sound Menu .
A01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_26880W_1810UK_10066680_50160569.indd 30 A01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_26880W_1810UK_10066680_50160569.indd 30
button?
English - 30 -

Remote Control

Your TV no longer responds to the remote control.
Perhaps the batteries are exhausted. If so you can still
use the local buttons at the bottom of the TV.

Input Sources

If you cannot select an input source, it is possible that
no device is connected.
Check the AV cables and connections if you have tried
to connect a device.
24.12.2009 10:05:33 24.12.2009 10:05:33