Getting Started - XciteRC 30408000 Buggy one12 Mode D'emploi

Getting started

Before you start, check all functions of the remote control. Does the vehicle follow exactly and directly your
commands? Or does it react delayed or choppy? If yes, do not start anyway, but check transmitter and drive
EN
batteries and recharge or replace if necessary.
The run time of your one12 4WD depends on the surface. The maximum run time is reached on a straight
and levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller
and battery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops com-
pletely. To increase the life time of the drive battery, you should cease operation when the vehicle begins to
slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
2. Switch the vehicle ON.
to connect the transmitter with the reciever properly.
3. Drive:
A
20
Note: wait about 5 sec. before you move the throttle trigger. This is needed
1x C
2x D
B
A
C
Getting started
B
D
one12 4WD series