Battery Charging; Charging Via Transmitter; Charging Via Usb Port; Getting Started - XciteRC Flybar 180S Coax Mode D'emploi

Battery charging · Getting started

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fi reproof surface and under constant adult supervision -
fi re or explosion hazard!

Charging via transmitter

• Turn on the transmitter.
• Now plug the charging adapter into the USB port on the bottom side of the transmitter. Connect the
helicopter to the adapter. The helicopter must be switched off!
• The red LED starts to light solid and displays the charging process. Charging time is about 50-60 minutes.
If the battery is fully charged, the red LED turns off.
• If the red POWER LED fl ashes, the transmitter batteries need to be changed.

Charging via USB port

• Insert the USB plug into a suitable socket on your PC or notebook (or power adapter with USB socket).
Connect the helicopter to the adapter. The helicopter must be switched off!
• The red LED starts to light solid and displays the charging process. Charging time is about 50-60 minutes.
If the battery is fully charged, the red LED turns off.
A
The fl ight time of the helicopter is about 6-8 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a suffi ciently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the fl ying qualities.
• Switch on the transmitter. The POWER LED fl ashes.
• Then switch on the model. The red LED on the receiver board starts to fl ash.
Place the helicopter in the start position and move the left throttle lever all the
way up and then back in the lowest position. This safety circuit prevents the rotor
may start after turning ON the helicopter
• The transmitter LED and the red helicopter LED will now light.
• Check the motor and servo functions.
• If the fl ight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the fl ight battery again.
XciteRC Flybar 180S Coax
USB USB
B
PC
OFF
ON
EN
OFF
17