After The Ride; Chassis Tuning Guide; Maintenance - XciteRC 30408000 Buggy one12 Mode D'emploi

After the ride · Maintenance
4. Steering trim: Drive slowly forward on level ground. Now check the straight ahead driving and adjust with
the ST.TRIM knob if neccessary.

After the ride:

1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
WARNING: remove the batteries from the model – fire hazard!
2.

Chassis Tuning Guide

On your one12 4WD chassis the toe of the front axle can be adjusted. The setting is done via the steering
linkage. More toe-in gives a better directional stability, but also poorer turn in at corner entry, and generally
a less direct steering.
More toe-out effects a direct response to steering commands and more aggressivity at corner entry, but is
also more difficult to control.
A neutral setting reduces tire wear and gives a neutral handling.
neutral
Toe-out Toe-in
adjust here

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
one12 4WD series
neutral
Toe-in Toe-out
adjust here
EN
21