Charging The Battery; Insert The Battery; Getting Started - XciteRC Sand Storm one10 2WD brushed blue Mode D'emploi

Charging · Getting started
• Make sure that no other 2.4 GHz network (eg. WLAN or other transmitter) sends nearby.
• The distance between transmitter - Sand Storm one10 should be maximum one meter.
• Insert the supplied BINDING plug into channel 4 of the receiver and then turn the vehicle on. Press and
hold the PAIR button on the transmitter and turn it on. The green LED of the transmitter and the receiver's
LED starts fl ashing to indicate the binding process. After about 5 seconds, both transmitter LEDs light up
continuously - as well as the LED of the reciever, the transmitter is now bound to the Sand Storm one10.
• To activate the failsafe function, set the steering and throttle trim to the center position and remove the
BINDING plug. In the event of a transmission failure (eg exceeding the maximum range or empty transmit-
ter batteries), the model does not react uncontrollably, just rolls to a halt in a straight line.
• If the model cannot be controlled, repeat the process.
• WARNING: Never operate your model with inserted BINDING plug! Use it only during the BINDING pro-
cess - risk of crash!

Charging the Battery:

Before the fi rst use of your new model the drive battery needs to be charged.
ATTENTION: Make sure to read all safety instructions regarding the use of rechargeable batteries.
Also, if necessary, further safety instructions in the manual for your used charger.
WARNING: Charge may occur only with the supplied charger on a fi reproof surface and under cons-
tant adult supervision - fi re or explosion hazard!
For charging remove the battery from the vehicle.

Insert the battery

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of
the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed
or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if
necessary.
The run time of your Sand Storm one10 depends on the surface. The maximum run time is reached on a
straight and levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed
controller and battery gets much warmer. If the battery is weak, the vehicle fi rst gets slower until it fi nally
stops completely. To increase the life time of the drive battery, you should cease operation when the vehicle
begins to slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
2. Switch the vehicle ON.
to connect the transmitter with the reciever properly.
Sand Storm one10
ON
Note: wait about 5 sec. before you move the throttle trigger. This is needed
EN
21