Repairs, Spare Parts; Troubleshooting - XciteRC 30408000 Buggy one12 Mode D'emploi

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
EN
• Also check all connections, cables and power battery / rechargeable battery for damage.
•
WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Repairs, Spare parts

Normal wear and defective parts that result from an accident, are excluded from the warranty. These include
in particular:
for car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
ship models: damaged or broken propellers, torn superstructure
airplanes: damage due to improper transport or crash
If you find a part that is defective in material or workmanship right after opening the package, return - before
you used it – to your dealer or directly to us and we will send you a replacement.
For the one12 4WD all parts are available as spares. If a part is defective or worn, you can identify it with the
help of the online spare parts list.
In case of problems or questions, please contact your dealer or:
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 /
7161 40 799 50
Email: service@xciterc.de
Spare parts for the one12 4WD you may order in your local hobby shop or online at http://www.XciteRC.com

Troubleshooting

Problem
Motor does not
run
Weak motor / no
power
Vehicle is hard to
control
22
Possible Cause
Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Motor broken
Battery is almost empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Transmitter LED flashing - transmitter
batteries almost empty
Steering trim ST.TRIM on the transmitter
set incorrectly
Interference
Throttle trim TH.TRIM on the transmitter
set incorrectly
Troubleshooting · Repairs
Solution
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Change or charge the battery
Check transmitter, set trim correctly
Check drive train and clean if necessary
Check pinion clearance, adjust if neces-
sary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make
a quick break and then re-try
Set throttle trim to the center position
one12 4WD series