Insert The Drive Battery; Getting Started - XciteRC One12 Série Mode D'emploi

Insert the drive battery · Getting started
2
• If the battery is connected with the Micro-Charger, the red LED indicates that the battery is charged. The
charging time is approx. 2.5 hours.
• The green LED indicates the end of the charging process, disconnect the battery from the charger.
• Unplug the AC adapter.

Insert the drive battery

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of
the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed
or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if
necessary.
The run time of your One12 depends on the surface. The maximum run time is reached on a straight and
levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller and bat-
tery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops completely. To
increase the life time of the drive battery, you should cease operation when the vehicle begins to slow down.
1. Switch on the vehicle, ON/OFF-switch in position ON.
2. Switch the transmitter ON.
needed to connect the transmitter with the reciever properly - the transmitter LED stops flashig and lights
solid now.
ON
Buggy
one12 Serie
1 3
Note: wait about 5 sec. before you move the throttle trigger. This is
ON
Truggy/Truck
ON
SC
EN
19