Preparation; Charge Your Robovac - EUFY RoboVac 15C Manuel D'utilisation

English
f Anti-drop sensors prevent RoboVac from tumbling down stairs and steep drops. They
may work less effectively if dirty or used on reflective/very dark-colored floors.
Place physical barriers in front of fireplaces and areas that may cause damage to
RoboVac if entered.

Preparation

Install the side brushes before use.
Turn on the main power switch on the bottom of RoboVac.
Remove the sticker next to the power switch, and the foam blocks beside the
bumper before use.
10
Place the Charging Base on a hard, level surface and against a wall.
Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the
front of the Charging Base.
Connect the round connector of the adapter into the power socket on the Charging
Base and the other end into a wall outlet.
• When the Charging Base connects to AC power, the LED indicator on the
Charging Base is SOLID WHITE.
- Install the Charging Base in a location that RoboVac - Install the Charging Base in a location that RoboVac
can easily access. It is recommended to place the
T can easily access. It is recommended to place the
Charging Base against a wall, and on a hard-level Charging Base against a wall, and on a hard-level
surface rather than on rugs or carpets.
surface rather than on rugs or carpets.
- Always keep the Charging Base plugged in, otherwise - Always keep the Charging Base plugged in, otherwise
RoboVac will not automatically return to it. RoboVac will not automatically return to it.

Charge Your RoboVac

• RoboVac has a pre-installed rechargeable battery that has to be fully charged before
use.
• RoboVac returns to the Charging Base at the end of a cleaning cycle or when its
battery is running low.
English
11