EIBENSTOCK EOF 100.1 Mode D'emploi page 16

Before use, make sure that the tool is correctly fixed and fastened.

Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction

hose to the back away from the machine.
Power tools have to be inspected by a specialist in regular intervals.

Never carry the machine at its cable.

Do not touch rotating parts.

Persons under 16 years of age are not allowed to use the tool.

During use, the operator and other persons standing nearby have

to wear suitable ear protectors, a dust mask and protection
goggles.
Make sure that persons in the work space are not endangered by

particles flying around.
Keep the handles dry, clean and free of oil and grease.

During operation, always hold the tool with both hands.

Attention! The tool still runs for a little while after the machine was

switched off.
For further safety instructions, please refer to the enclosure!
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The grinder is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unintended responding.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Electrical Connection
Cross section in sq. mm
1.5
-
50 m
16
2.5
40 m
80 m