EIBENSTOCK EOF 100.1 Mode D'emploi page 15

Use only milling disks recommended by the manufacturer. They have
a low weight and a high rotation accuracy.
The use of other milling disks can cause damage to the device or a
danger for the operator and leads to termination of the guarantee.
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and follow the
instructions contained strictly. Additionally, the general
safety instructions of the leaflet supplied with the tool
must be observed. Prior to the first use, the user should
absolve a practical training. Save all warnings and
instructions for future reference.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
Do not use the tool in an environment with danger of explosion.

Do not drill into asbestos-containing materials.

Modifications of the tool are prohibited.

Never use the machine without dust guard.

Use machine with partly removed dust guard in corners only.
For other applications the dust guard must always be closed.
Always check the tool, cable and plug before use and plug before use.

Have damages only repaired by specialists.
Insert the plug into the socket only when the tool switch is off.
When you work outside, the machine has to be used with a fault-

current circuit breaker with max. 30 mA.
The machine should only work under supervision of somebody.

Plug and switch the machine off if it is not under supervision, in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it

starts suddenly and not under supervision.
Don't use the machine if a part of the housing is damaged or in case of

damages on the switch, the cable or plug.
Pay attention that the speed indicated on the grinding wheel meets or

is higher than the max. speed indicated on the machine.
Milling disks have to be stored and used carefully according to the

instructions of the producer.
Check the accessories before use. Do not use any products which are

broken, cracked or damaged in another way.
15