Automatic Power Saving Function; Troubleshooting - Teac W-1200 Mode D'emploi

Automatic power saving function

ATTENTION
The automatic power saving function is only included in
European models.
The automatic power saving function is ON when this unit is shipped
new, so it will automatically turn off if 30 minutes pass under the
conditions shown below.
Status
No cassette tape
Stopped
Recording paused
 Automatic power saving function active
– Automatic power saving function not active
To reactivate the unit after it has turned off automatically, press the
POWER button on the main unit twice.
Changing the automatic power saving
setting
1 Stop both TAPE 1 and TAPE 2.
2 Press the TAPE 1 and TAPE 2 (8) buttons at the
same time to show the current setting ("Apwr
OFF" or "Apwr On") in the tape counter area.
3 Use the TAPE 2 play (y) button to change the
setting.
4 Press the TAPE 2 stop (8) button to return to
the ordinary state.
Cassette tape


–

Troubleshooting

If you experience a problem with the unit, please take a moment
to review the following information before requesting service.
Moreover, the problem might be caused by something other than
this unit. Please also check the operation of the connected units.
If it still does not operate correctly, contact the retailer where you
purchased the unit.
The unit does not turn on.
e Check that the power cord is plugged into a working power
outlet.
e Check that the power cord is properly connected to this unit.
e Check that the power cord is completely plugged into the
power outlet.
When the unit is turned on, playback/recording starts
unexpectedly.
e Set the TIMER switch to OFF.
Remote control does not work.
e Press the POWER button to turn the unit on.
e If the batteries are exhausted, replace both of them with new
ones.
e Point the remote control at the front panel of the unit from a
distance of less than about 5 m (16 ft).
e The remote control will not work if there is an obstruction
between it and the main unit. In this case, try changing the
position.
e Turn off any strong light source near this unit.
When using the remote control, a television or another
device operates in error.
e The use of this unit's remote control might cause some tele-
visions with wireless remote control functions to operate
incorrectly. If this should occur, use the main unit's buttons.
The unit does not respond when buttons are pressed.
e The unit sometimes does not respond when buttons are
pressed during operation. Try pressing the button again after
waiting a little while.
e Load a cassette if one is not already loaded.
e Insert the cassette correctly.
Continued on the next page
e
29