Returning To Zero - Teac W-1200 Mode D'emploi

Pitch control (TAPE 1 only)
The pitch can be controlled during TAPE 1 playback.
Turning the PITCH CONTROL knob clockwise (toward +) increases
the playback speed and raises the pitch.
(The maximum is 12%, which is about two semitones higher.)
Turning this knob counterclockwise (toward −) reduces the play-
back speed and lowers the pitch.
(The maximum is 12%, which is about two semitones lower.)
o This function is disabled when recording and dubbing. This can
only be used to adjust playback.
Tape counter
Press a COUNTER RESET button to reset that tape counter to "
You can use this function for easy relocation of any desired point on
the tape. Using this with the "Returning to zero" function described
in the following section can be convenient.

Returning to zero

Press the RETURN TO ZERO button to fast-forward or rewind the
TAPE 1 or TAPE 2 until the counter reaches "
stops.
o This function cannot be used if the counter is between "
and " ".
".
" and the tape
"
17