Timer-Controlled Recording - Teac W-1200 Mode D'emploi

5 Set the timer to your desired start (power on)
and stop (power off) times.
When this setting is completed, the power to all components
should be turned off.
At this time, do not press this unit's POWER button.
Leave the button pushed in (the on position). If the
POWER button is in the off position, timer playback will
not function.
When the timer on time is reached, the timer will supply power
to the connected devices and playback will start.
o When you do not want to use the timer, set the TIMER
switch to OFF.

Timer-controlled recording

o Timer recording sources are limited to connected equipment
that can be operated by timer. This can be used for timed record-
ing of radio broadcasts, for example.
o A timer cannot be used for dubbing from TAPE 1 to TAPE 2.
1 Connect the W-1200 and the other equipment
to a commercially-available timer as shown in
the illustration on the previous page.
Set the power switches of all components to
2
ON.
3 Load the cassette tape that you want to use for
timer recording.
o If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s).
o This unit can record to normal (type I) and chrome (type II)
tapes.
4 Set the TIMER switch to REC.
5 (When recording from radio)
Tune in the radio station that you want to
record.
Continued on the next page
e
27