Parallel Recording; Recording With A Computer; Supported Operating Systems - Teac W-1200 Mode D'emploi

Parallel recording

This function allows you to record the same source from a con-
nected device to both TAPE 1 and TAPE 2 simultaneously.
Load cassette tapes for recording into both the
1
TAPE 1 and TAPE 2 compartments.
o If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s).
2 Follow recording procedure steps 2–3 on
pages 18–19 to adjust the recording level.
3 Press the TAPE 1 stop (8 ) button to end
recording standby.
4 Press the PARALLEL REC (parallel recording)
button to start recording.
PARALLEL will appear on the display.
o When using the remote control, press both PARALLEL REC
(parallel recording) buttons on it at the same time.
o Parallel recording cannot be started when paused. Stop the
unit before starting.
o The TAPE 2 REC MUTE (record muting) button can be used to
record silences even during parallel recording (page 20).
(The TAPE 1 REC MUTE (record muting) button cannot be
used.)
Pausing parallel recording
Press the TAPE 2 PAUSE button.
Press it again to resume parallel recording.
Stopping parallel recording
Press the TAPE 1 or TAPE 2 stop (8) button.
o When source playback stops, recording does not automatically
stop.
24

Recording with a computer

Connect this unit to a computer using a commercially-available USB
cable to convert audio signals from a cassette tape to digital data
and send them to the computer.

Supported operating systems

Computers running the following operating systems can be con-
nected by USB to this unit. Use with operating systems other than
these is not guaranteed (as of November 2017).
Windows
Windows 7 (32-bit, 64-bit)
Windows 8 (32-bit, 64-bit)
Windows 8.1 (32-bit, 64-bit)
Windows 10 (32-bit, 64-bit)
Mac
OS X Lion (10.7)
OS X Mountain Lion (10.8)
OS X Mavericks (10.9)
OS X Yosemite (10.10)
OS X El Capitan (10.11)
macOS Sierra (10.12)
macOS High Sierra (10.13)
o This unit will run with the standard OS driver, so there is no need
to install a special driver.