Fastening The Adjusting Rib To The Furniture Door (Refrigerator Compartment); Fastening The Fixing Rib To The Furniture Door (Refrigerator Compartment) - Gaggenau RY 492 Instructions D'installation

7. Fastening the adjusting rib to
the furniture door
(refrigerator compartment)
1. Measure distance A between the adjusting rail and
the furniture parts above.
2. Loosen the two nuts (a) and remove the adjusting rib
(b).
3. Mark this value A on the rear side of the furniture
door.
4. Determine the middle of the door and label it.
5. Rest the adjusting rib on the furniture door and align
to the markings. Mark the drill holes.
6. Pre-drill the holes.
7. Tightly screw the adjusting rib.
Note:
– Attach the adjusting rib with at least 6 screws on the
furniture door. One screw should be screwed in
under the threaded rod in each case.
– The adjusting rib has a various holes for different
furniture door design variations. Always carry out
screwing jobs on the most stable part of the furniture
door.
8. Fastening the fixing rib to
the furniture door
(refrigerator compartment)
Note:
The fixing ribs are pre-assembled for stainless steel
doors. In this case continue with the next installation step
("C / 9. Fastening the adjusting rib to the furniture door
(freezer compartment)").
1. Hang the furniture door on the threaded rod (a).
2. Adjust the furniture door using the threaded rod
(Torx screwdriver).
Re-examine the dimensions of the crack
continuously. To do this, use the assembly
gauge (b).
3. Transfer the position of the fastening screws on the
outer edge of the appliance door to the furniture
door and mark.
19