Random Sequential Tape-Programming (For Audio Cd) - Yamaha CDX-497 Mode D'emploi

Random sequential tape-programming (for Audio CD)

The unit automatically programs tracks in random sequential order for recording to tape.
1
Follow steps 1 – 3 on page 16.
2
Press RANDOM.
* The unit automatically programs tracks at random for
both side A and side B considering the total time of the
tape.
3
Start recording on the tape deck, and then press
on the remote control of this unit.
4
This unit automatically pauses at the end of the side
A. Turn the tape over to the side B, resume
recording on the tape deck, and then press
on the remote control of this unit to start
playback.
DIMMER
REPEAT
SYNCHRO
3, 4
TIME/INFO
RANDOM
or
RANDOM 2
A–B PROGRAM CLEAR
TAPE PEAK SPACE
SEARCH
4
FOLDER
Notes
● Because programmed data changes every time RANDOM is
pressed, the unrecorded space at the end of each side of the
tape also varies accordingly.
● All tracks may not be programmed if the tape length is not
enough. To program all tracks, use a tape that is longer than
the actual playing time.
● In step 2, you can check the program data for side A and side
B. Information for each side is displayed for 3 seconds.
1
1
Shows the number of programmed tracks.
2
Shows the total time of programmed tracks.
3
Shows the side of the tape.
● Up to 40 tracks can be programmed. A pause inserted between
side A and B is counted as one track.
● CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 3 and 4, press
SYNCHRO and then press
unit. Recording automatically starts. (For details, refer to page
21.)
2 3
PROG. RANDOM
on the remote control of this
19
En