Table des Matières
Publicité
Agitator Cleaning
Agitator Assembly
Assemblage de l'agitateur
Ensamble del agitador
End Cap
Bouchon
Tapa del extremo
Brush Unit
Agitateur
Unidad del cepillo
Cover
Couvercle
Cubierta
Base
Base
Base
Belt Path
Chemin de courroie
Ruta de la correa
End Cap
Bouchon
Tapa del extremo
- 44 -
➢ Reinstall agitator cover. Make sure
there is no gap between the agitator
cover and base.
➢ Line up front of cover and base. Rest
cover on front edge of base as
shown.
➢ Rotate cover back. Press cover
firmly until rear latches snap into
place.
➢ Make sure there is no gap between
the cover and base.
➢ Turn Power Nozzle upside down and
replace six (6) cover screws.
NOTE: In order to keep cleaning
efficiency high and to prevent damage
to your vacuum cleaner, the agitator
must be cleaned every time the belt is
changed.
➢ Check and remove hair, string and
lint build-up frequently in the Power
Nozzle agitator and end cap areas.
➢ Remove any dirt or debris in the
belt path area or in the brush unit
area.
➢ Carefully remove any string or
debris located on the agitator or
end caps.
Publicité
Table des Matières
