Control Panel And Features - Maytag W10560151A Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

1
1 LOAD SIZE
Select the setting most suitable for your load. Small will
add a low amount of water for smaller loads and Super
will add the most amount of water for large or bulky loads.
Items need to move freely. Tightly packing can lead to poor
cleaning performance, and may increase wrinkling and
tangling.
WASH TEMP
2
Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following the
garment label instructions, use the warmest wash water safe
for your fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
WASH CYCLE KNOB
3
Use the Wash Cycle knob to select cycles on your washer.
Knob does not advance during the progress of the cycle,
see cycle status lights for each stage of the process. See
"Cycle Guide" for detailed descriptions of cycles.
SOIL LEVEL
4
For most loads, select the most suitable setting for your
load. For heavily soiled and sturdy fabrics, select Heavy Soil
Level for more wash time, if needed. For lightly soiled and
delicate fabrics, select Light Soil Level for less wash time,
if needed. Lighter soil level setting will help reduce tangling
and wrinkling.
5 OPTIONS
The following options may be added to most cycles.
ONE RINSE
This option is used to limit a cycle to one rinse.
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
ONE RINSE with FABRIC SOFTENER
This option must be selected if using fabric softener
during a cycle. It ensures that fabric softener is added
at the correct time in the rinse for even distribution.
4
2
Not all features and options are available on all models.
Appearance may vary.
3
7 6
EXTRA RINSE with FABRIC SOFTENER
This option turns on both the Fabric Softener and the
Extra Rinse options.
START/PAUSE/UNLOCK BUTTON
6
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel a
cycle.
7
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle. At
each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
FILL
When the START/Pause/Unlock button is pressed, the
washer will fill to the selected water level. If the lid is
closed when the washer is done filling the lid will lock and
the washer will begin operation.
If the lid is open when the water stops entering the
washer, the cycle will not begin until the lid has been
closed and the START/Pause/Unlock button is pressed.
If the cycle has not been started within 10 minutes of
the water filling the washer, the washer will pump out the
water.
NOTE: Avoid opening lid during sensing phase. The
sensing process will start over when the washer is
restarted. The sensing light may also come on during the
Soak and Wash portions of the cycle. This is normal. To
restart the washer after the lid has been opened press
START.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
4 5