Important Safety Warnings; General Safety Warnings - EUROM Swift 1300 Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Specifications

Type

Voltage

Capacity

Reach

IP protections

Remote control

Dimensions

Weight

Attention!

Your patio heater will briefly decrease its peak current when it is switched on.

In some cases this can be too much for commonly used 16A-B installation machines

in the meter cupboard, with the result that they "break down". To have an

installation machine collect the peak current, you can have the 16A-B installation

machine replaced by a 16A-C (or D) installation machine. They break through less

quickly and thus better absorb the peak current.

With the classic porcelain fuses (stopping) in your meter cupboard, this problem is

less likely to occur; if it does happen, replace the fuse with a "slower" version.

If necessary, have a separate group installed for your patio heater. Then you do not

have to take into account other equipment connected to the same group and the

problem is unlikely to occur.

Introduction

Your Eurom Swift infrared heater warms up not primarily the air in the room, but all

objects before the heater. By means of that your infra red heater is effective and

very qualified to be used in the open air as well.

The Eurom Swift has some serious advantages:

- high degree of water tightness (totally dust- and watertight, IP65)

- the special 'Golden tube' lamp: a superior lamp with an expected lifetime of 8000

working hours. Under normal circumstances it will not be necessary to change the

lamp.

Use the infra red heater for the objective for which it is made: to heat (the object

in/on) a room or terrace. Don't hang for example wet textile over the lamp to dry,

but always notice the minimum distances to the equipment.