Franke FTC 601 WH/GL Mode D'emploi Et Installation page 7

INSTALLATION
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 135 mm above the bottom
surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using the drilling
template provided.
• Cut a hole ø 125 mm in size on the support surface, using the
drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provided.
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from underneath
the hood.
Hood Type 45
L1 360
• The space between the edge of the hood and the rear wall can
be closed by applying the element 20 provided, using the
screws 12b.
EN
SCREW FITTING
SNAP-ON FITTING
50 55 60
410 460 510
CLOSING ELEMENT
70 80 90
610 710 810
12a
125 125
262
15
L1
Vf
20
12b
7
7