Care And Cleaning - Zanussi ZGO68434BA Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Burner
Triple Crown
Semi-rapid

CARE AND CLEANING

WARNING! Refer to Safety chapters.
GENERAL INFORMATION
Clean the hob after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the surface have no
effect on how the hob operates.
Use a special cleaner applicable for the surface
of the hob.
WARNING! Do not use knives,
scrapers or similar instruments to
clean the surface of the glass or
between the rims of the burners and
the frame (if applicable).
Wash stainless steel parts with water, and then
dry them with a soft cloth.
PAN SUPPORTS
The pan supports are not resistant to
washing in a dishwasher. They must
be washed by hand.
1. Remove the pan supports to easily clean the
hob.
Be very careful when you replace
the pan supports to prevent the
hob top from damage.
2. The enamel coating occasionally can have
rough edges, so be careful when you wash the
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
Diameter of cook-
ware (mm)
180 - 260
120 - 220
Burner
Auxiliary
pan supports by hand and dry them. If
necessary, remove stubborn stains with a paste
cleaner.
3. After you clean the pan supports, make sure
that they are in correct positions.
4. For the burner to operate correctly, make sure
that the arms of the pan supports are aligned
with the centre of the burner.
CLEANING THE HOB
Remove immediately: melted plastic, plastic
foil, sugar and food with sugar. If not, the dirt
can cause damage to the hob. Take care to
avoid burns.
Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny
metallic discoloration. Clean the hob with a
moist cloth and non-abrasive detergent. After
cleaning, wipe the hob dry with a soft cloth.
To clean the enamelled parts, cap and crown,
wash them with warm soapy water and dry them
carefully before you put them back on.
CLEANING THE SPARK PLUG
This feature is obtained through a ceramic ignition
candle with a metal electrode. Keep these
components well clean to prevent difficult lighting
and check that the burner crown holes are not
obstructed.
PERIODIC MAINTENANCE
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
Diameter of cook-
ware (mm)
80 - 160
11

Publicité

Table des Matières
loading

Table des Matières