Product Description Tai Wd; Installation; Preparation - Dovre TAI 45 W Installation Et Mode D'emploi

Product description TAI WD

5
7
1
4
2
3
6
8
1. Door
2. Latch
3. Fire basket
4. Bottom of the fire compartment
5. Flue gas connection
6. Primary air slide
7. Secondary air slide (glass wash)
8. Leg
9. Side filling door

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Subject to change because of technical improvements
1. Open the door; see the following figure:
9
09-20021-111
2. Remove the fire-resistant inner plates; see the fol-
lowing figure:
a. Remove the fire basket (5).
b. Raise the baffle plate (1) at the front, pull the
c. Remove the inner plates on the left and right
d. Remove the inner plates on the back (2).
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
baffle plate 2 cm forwards and allow the baffle
plate to drop down at the back
sides (3).
Vermiculite inner plates are light and tend
to be ochrous in colour on delivery. They
insulate the combustion chamber to boost
09-20021-112
11