Part Information; Installation - Cavavin B-015WSZ Manuel D'instruction

Part Information

1. Hinge Cover
1. Electronic Control Panel and Display
2. Shelves
3. Wine Bottle Guard Bar
4. Lock
5. Adjustable Feet

Installation

IMPORTANT: Sobra Wine Cellars are strictly for free standing installation only. Models without front venting (air
opening) should never be built-in. Any built-in installation will void the warranty.
−
Read the instruction manual.
−
The unit requires a standard 120 volt power point.
−
Unpack and remove all of the protection and adhesive strips from the packaging around and inside the wine
cellar.
−
Allow 5 inches (13cm) of space between the back and sides of the wine cellar.
−
The wine cellar must be positioned such that the plug is accessible. Release the power cord. Move your wine
cooler to its final location. The wine cooler should be installed in a suitable place where the compressor will
not be subject to physical contact.
−
Leveling your wine cellar: Units must be leveled BEFORE loading your wines. The unit is equipped with 4
adjustable feet to facilitate easy leveling. It's recommended that you tighten the back feet to the maximum and
adjust the front feet to level the unit.
−
As with most appliances of today, the wine cellar has sensitive electronic components which are susceptible
to damage through lightning and electricity supply faults. It is therefore advised to use a power surge protector
to avoid problems of this nature.
19