Check Before Lighting - Cola DIAMOND Manuel D'installation, D'utilisation Et D'entretien

Button Description
1
Increase temperature
Decrease
2
temperature
3
Setting/menu
4
ON/OFF reset
5
Decrease power
Increase
6
power
The Figure opposite describes the meaning of the status indicators in the left
part of the display.
Activation of one of the segments on the display signals activation of the
corresponding device according to the list opposite.
4.3 Lighting

4.3.1 Check before lighting

Before lighting the stove:
- make sure you have read and understood that given in the manual;
- the hopper must be filled with pellets;
- the combustion chamber must be clean;
- the brazier must be completely free, cleaned of any combustion residuals and correctly fitted in the brazier
holder;
- check hermetic closing of the fire door and ash pan;
- check the connection of the power cable and switching to ON/1 of the switch located on the back of the stove.
- At first startup, remove all the components (instructions/label) that could burn from the stove firebox
and glass.
- Any lightings done after long stove idle periods require the renewal of any pellets that have been inside
the hopper for a long time, in being a damp fuel no longer suitable for combustion, and complete
cleaning of the combustion chamber.
Mode
PROGRAMMING Modify/increase selected menu value
WORK/OFF Increase room thermostat temperature value
PROGRAMMING Modify/decrease selected menu value
WORK/OFF Decrease room thermostat temperature value
-
Access MENU
MENÚ Access next submenu level
PROGRAMMING Set value and go to next menu item
WORK Press for 2 seconds to switch the stove on or off (if off or on)
BLOCK
Resets the stove and returns it to off status
Goes to higher menu level. The modifications made are
PROGRAMMING
memorised
WORK/OFF Modifies stove heat output
MENÚ
Go to next menu item
Return to next submenu item. The modifications made are
PROGRAMMING
memorised
WORK/OFF Modifies exchanger speed
MENÚ
Go to previous menu item
Go to previous submenu item. The modifications made are
PROGRAMMING
memorised
44
Action
external contact
chrono
igniter
auger
fume extractor
exchanger
not used
alarm
DIAMOND